Alpine dha-s680 Guía Del Usuario
44
-EN
Installation and Connections
Mounting
Mounting the remote control sensor unit
NOTES
• When using a monitor with a built-in remote control
sensor, such as the CVA-1006, the external sensor is
not used.
not used.
• When mounting the unit with double-sided adhesive
tape, make sure the mounting surface is dry and
free from dirt or grease.
free from dirt or grease.
Press the double-sided adhesive tape onto the
back of the remote control sensor unit.
back of the remote control sensor unit.
Before completing the sensor mounting, make
sure the location selected is within the operating
range of the remote control. Peel off the backing
of the adhesive tape and press the sensor onto
the selected mounting location, or inside of the
remote control holder.
sure the location selected is within the operating
range of the remote control. Peel off the backing
of the adhesive tape and press the sensor onto
the selected mounting location, or inside of the
remote control holder.
Remote Control
Sensor Unit
Sensor Unit
Remote Control
Holder
Holder
Remote Control
Reinforcement Screws
Console Box etc.
Remote Control Holder
*
Blue Protective
Paper
Installation
Caution
Be careful that the vehicle's wiring does not
touch the DHA-S680.
If the wiring comes in contact with the DHA-
S680, their insulation may be damaged due to
vibrations generated while the vehicle is
running. This can result in short-circuits. Make
sure there is enough clearance between the
DHA-S680 and the vehicle’s wiring to prevent
contact.
Be careful that the vehicle's wiring does not
touch the DHA-S680.
If the wiring comes in contact with the DHA-
S680, their insulation may be damaged due to
vibrations generated while the vehicle is
running. This can result in short-circuits. Make
sure there is enough clearance between the
DHA-S680 and the vehicle’s wiring to prevent
contact.
NOTES
To prevent external noise from entering the audio
system.
• Locate the unit and route the leads at least 10 cm
system.
• Locate the unit and route the leads at least 10 cm
away from the car harness.
• Keep the battery power leads as far away from other
leads as possible.
• Connect the ground lead securely to a bare metal
spot (remove any paint, dirt or grease if necessary) of
the car chassis.
the car chassis.
• If you add an optional noise suppressor, connect it as
far away from the unit as possible. Your Alpine dealer
carries various noise suppressors. Contact them for
further information.
carries various noise suppressors. Contact them for
further information.
• Your Alpine dealer knows best about noise prevention
measures so consult your dealer for further
information.
information.
When the DHA-S680 is connected with an Alpine
Ai-NET products (AV head unit, regular head
unit, etc.), it’s system settings (Ai-NET and H.U.
Control settings) must be selected. Before
finalizing installation, be sure to change the
system settings as described on page 48.
Ai-NET products (AV head unit, regular head
unit, etc.), it’s system settings (Ai-NET and H.U.
Control settings) must be selected. Before
finalizing installation, be sure to change the
system settings as described on page 48.
5
Turn off the DHA-S680’s power.
6
Remove the ignition key and disconnect the
battery’s negative terminal.
battery’s negative terminal.
Mounting the remote control holder
• If the remote control is in direct sunlight,
remove it from the holder and keep it in the
glove box.
glove box.
• When the holder cannot be mounted
securely with Velcro tape, mount it by using
screws.
screws.
*
Velcro tape (Before putting on the holder,
clean dirt on the mounting location.)
clean dirt on the mounting location.)
3
4
1
2