Grindmaster d-15 Manual Suplementario
Assembly (cont.)
PRESS SPRING UP INTO PLACE
AGAINST THE BOTTOM
OF THE BOWL.
ASSEMBLE THE RUBBER INLET ADAPTER
Assemble white rubber
inlet adapter by stretching one
end over the large tubular inlet
on top of the whipper housing.
Attach the other end over the
ring sleeve on the underside of
the handle.
INSERT HANDLE INTO “V” NOTCHES AND PLACE
VALVE INTO HOLE.
VALVE INTO HOLE.
TURN VALVE 90° TO LOCK.
Cross slot (located on top of
valve) should run left to right
Cross slot (located on top of
valve) should run left to right
across the bowl when
locked.
locked.
PUSH WHIPPER BLADE INTO PLACE.
Replace the whipper blade by
lining up the flat inside the blade
Replace the whipper blade by
lining up the flat inside the blade
with the flat side of the motor shaft. Push
blade firmly into place.
blade firmly into place.
REPLACE WHIPPER CHAMBER.
Replace whipper chamber by
positioning the medium-sized
positioning the medium-sized
opening up and tilting 1/8 turn
to the right. Put whipper
chamber over whipper blade
to the right. Put whipper
chamber over whipper blade
and turn to the left until it locks
into place.
9
HANDLE SHOULDERS GO
INTO “V’ NOTCHES
RINGSLEEVE
DOWN
DOWN
VALVE HOLE
SPRING
VALVE HOLE
SPRING
10
“W” IS
WHIPPER
VALVE
WHIPPER
VALVE
TOP
14
(LOOKING DOWN INTO BOWLS)
CROSS-SLOT
VALVE DOWN IN HOLE
READY TO LOCK
AFTER 90° TURN,
VALVE IS LOCKED
I/ON
SPRAY
O/OFF
I/ON
REFRIG.
O/OFF
Ring sleeve on
bottom of handle
bottom of handle
Rubber inlet
adapter
adapter
Plastic whipper
housing
housing
11
12
13
FILL BOWLS WITH PRODUCT
and replace lids on bowls.
Turn spray switch on first then refrigeration.
Turn spray switch on first then refrigeration.
15
SPRING
VALVE
HOLE
Crathco® Beverage Dispensers
Page 4