Grindmaster d-15 Manual Suplementario

REMOVE PUMP COVER

Remove pump cover by 

lifting up on spray tube.

STANDARD & MINI UNITS:
REMOVE VALVE AND HANDLE

Lift valve. Handle drops into 
operator’s other hand.

WHIPPER UNITS:
• DISASSEMBLE THE RUBBER INLET

ADAPTER

Remove one end from the large tubular inlet 
on top of the whipper housing and the 
other end from the ring sleeve on the 
underside of the handle.

• REMOVE WHIPPER CHAMBER

Turn whipper chamber to the right until it 
releases and you can pull it off of the 
whipper blade.

• REMOVE WHIPPER BLADE

Pull whipper blade off of the motor shaft.

• TURN VALVE 90° TO UNLOCK. 

REMOVE HANDLE AND VALVE. 

• REMOVE SPRING FROM

BOTTOM OF BOWL.  

REMOVE BOWL AND 
BOWL GASKET

Twist bowl back and forth while

lifting up. Bowl gasket will be
around bottom of bowl. 

NOTE: On D112 units, bowl gasket 
will be around cooling dome.

REMOVE IMPELLER AND 
BEARING SLEEVE
Remove impeller and 

bearing sleeve by lifting 
them straight up.

NOTE: Check impeller and 
bearing sleeves for wear. 
See page 7.

THOROUGHLY CLEAN ALL PARTS IN WARM WATER 

USING A MILD NON-ABRASIVE DETERGENT AND 

RINSE THOROUGHLY.

CAUTION: ABRASIVES WILL SCRATCH PLASTIC PARTS.
WASH BOWL LIDS IN COOL OR LUKEWARM WATER TO 

AVOID LEAKS DUE TO SEALED SURFACE BEING 

DAMAGED.

REMOVE LOCKDOWN WASHER(S)

SANITIZE

Immerse parts in sanitizing solution for 1-2 minutes. 
Remove parts from sanitizing solution and drain.
DO NOT RINSE. Place parts on a clean surface to air dry.
Wipe the machine, condensate tray and cooling plate 
depression with a cloth wetted with sanitizer solution. 

IMPORTANT: Never pour dry powder, crystals, or concentrate 
into a dry bowl. Premixing beverage in separate container is
recommended. If mixing in bowl, always add water first.

Standard Unit: Twist lockdown 
washer counterclockwise, slide
to release keyway. Then lift out.

Mini Unit: Slide to release 
keyway, then lift out.

D112 Unit: Release each clamp.

DRAIN ALL BEVERAGE FROM BOWLS

A. Remove bowl lid(s) and drip tray(s)
B. Drain through valve then
C. Tip unit forward, gently press spray 

tube back a short distance to lift the 
edge of the pump cover to allow 
remaining beverage in well to be 
drained through valve. 

Ring sleeve on 
bottom of handle

Rubber inlet 
adapter

Plastic whipper
housing