Nortel 1010 Manual De Usuario
Chapter 1 Hardware overview 25
Nortel VPN Router Installation — VPN Router 1010/1050/1100
Rear view of the gateway
shows the rear view of the VPN Router 1010, 1050, and 1100.
Figure 5
Rear view of the VPN Router 1010/1050/1100
The components on the rear of the gateway include the following:
•
The port labeled “DC Input” is the receptacle for the external power supply
that is shipped with the VPN Router 1010, 1050, and 1100.
that is shipped with the VPN Router 1010, 1050, and 1100.
•
Mechanical on/off switch.
•
The Power LED is green when power is supplied to the unit and the internal
power converters are not in a protective shutdown state.
power converters are not in a protective shutdown state.
•
The recessed recovery switch boots the recovery image. To boot the recovery
image, press the switch by inserting a paper clip into it during the power-on
self-test memory test. For more information about system recovery, see
Nortel VPN Router Troubleshooting (NN46110-602).
image, press the switch by inserting a paper clip into it during the power-on
self-test memory test. For more information about system recovery, see
Nortel VPN Router Troubleshooting (NN46110-602).
•
You use the ground screw (GND) to ground the chassis.
•
The label on the rear panel lists the media access control (MAC) addresses for
LAN 0 and LAN 1.
LAN 0 and LAN 1.
Note: Nortel recommends that you wait 5 seconds after you turn off the
gateway before you turn it on again.
gateway before you turn it on again.
10679EA
DC Input
19V/3.16 A
60W max.
Power
RC
DC power supply
On/Off switch
Power LED
Recovery switch
Ground screw
LAN0 Private MAC Address
LAN1 Public MAC Address
Label
1
0