Extreme wm100 Guía Del Usuario
HWC_GSG_RouterConfiguration.fm
Routing configuration
Configuring the OSPF routing
120385-00 Rev 01, March 2007
Summit WM, Getting Started Guide
Summit WM, Getting Started Guide
57
•
Default – Acts as the backbone area (also known as area zero). It forms
the core of an OSPF network. All other areas are connected to it, and
inter-area routing occurs via a router connected to the backbone area.
the core of an OSPF network. All other areas are connected to it, and
inter-area routing occurs via a router connected to the backbone area.
•
Stub – Does not receive external routes. External routes are defined as
routes, which are distributed in OSPF via another routing protocol.
Therefore, the Stub area relies on a default route to send traffic routes
outside the present domain.
routes, which are distributed in OSPF via another routing protocol.
Therefore, the Stub area relies on a default route to send traffic routes
outside the present domain.
•
Not-so-stubby – A type of stub area that can import autonomous system
(AS) external routes and send them to the default/backbone area, but can
not receive AS external routes from the backbone or other areas.
(AS) external routes and send them to the default/backbone area, but can
not receive AS external routes from the backbone or other areas.
8. To save your changes, click Save.
5.2.2 Defining the global OSPF parameters
To define the global OSPF parameters:
1. From the main menu, click Summit Switch Configuration. The Summit
Switch Configuration screen is displayed.
2. In the left pane, click Routing Protocols. The Routing Protocols screen is
displayed.
3. Click the OSPF tab.
4. From the Port Status drop-down list, click Enabled. The OSPF is enabled on
the port.
Note: Only the interfaces defined as router type are available for OSPF neighborhood
establishment.
establishment.
5. In the Link Cost text box, type the OSPF standard for your network for this
port.
The Link Cost is the cost of sending a data packet on the interface. The lower
the cost, the more likely the interface will be used to forward the data traffic.
the cost, the more likely the interface will be used to forward the data traffic.
Note: If more than one port is enabled for OSPF, you must prevent the Summit WM
Switch from serving as a router for the other traffic. In order to do this, you must set
the Link Cost to its maximum value of 65535.
Switch from serving as a router for the other traffic. In order to do this, you must set
the Link Cost to its maximum value of 65535.
6. From the Authentication drop-down list, click the authentication type of
OSPF on your network:
•
None: The default is None. If None is selected, leave the Password text
box blank.
box blank.