Citel 6000 Guía De Instalación
EXTender 6000 Quick Installation Guide
19
Synchronous-Serial (RVP_Direct)
This section of the manual provides the necessary information to configure the EXTender for
connection to a synchronous-serial device. The units are programmed at the factory with
“default” settings providing basic parameters to accommodate many network environments.
connection to a synchronous-serial device. The units are programmed at the factory with
“default” settings providing basic parameters to accommodate many network environments.
Public
Branch Office
Punch Block
EXTender 6000
Punch Block
PBX
Corporate Office
PBXgateway
Router
DSU/CSU
DSU/CSU
Router
Figure 7:
RVP_Direct Installation
Prerequisites for Configuration
• The Gateway (at the corporate site) and the EXTender (at the branch office) must be installed
properly and the network link between both devices must be operational.
• The network administrator must assign an IP address for both units if you plan to configure and test
them over a LAN or WAN.
Table 6:
Configuration Steps
You must......
To......
Default
Setting
Setting
Refer
to...
to...
Set Connect
Parameters
Parameters
Select network type
RVP_Direct
Setup the WAN ports
Enable WAN ports to connect to
network device.
network device.
WAN 1 -
Enabled
Enabled
Set the Sync Rate of
the WAN port
the WAN port
Match the data rate (sync rate) of the
network device
network device
512,000 kbps
Set the mode (interface
type) of the WAN port.
(v.35, RS-232, RS-530)
type) of the WAN port.
(v.35, RS-232, RS-530)
Match the interface type of the network
device.
device.