Citel 6000 Guía Del Usuario
PBXgateway
™
& EXTender
TM
6000 System Administrator’s Guide
61
Setting PBXgateway and EXTender Parameters
IMPORTANT: Changes made in this section, via the MI, are saved to the “Active” config file
stored on the Gateway and EXTender unit. All configuration files are saved with a .rem extension
for Remote unit files, and a .swt extension for PBXgateway files. The MI will prompt you to save
changes as necessary. There are options for saving these parameters under a different file name,
or creating and editing a “non-active” configuration file. (see page 175, for more information)
IMPORTANT INFORMATION
Initial MI Connection
The initial set up of the PBXgateway MUST be done through a direct serial connection (see page
44), until the IP parameters have been entered (see page 76) allowing configuration via Telnet
through the Ethernet port.
Default Settings
The units are programmed at the factory with “default” settings providing basic parameters to
accommodate many network environments. It may be necessary to change these settings
depending on the network.
Set up Wizard
This is a setup program accessed through a direct-serial connection. The wizard prompts you to
enter required information necessary for configuring the PBXgateway. (see page 104, for more
information)
Multiple Remotes (RVP_Over_IP only)
The PBXgateway can interface with multiple clients from one to twelve users. It is necessary to
know the type of Remote units that are communicating with the PBXgateway for proper
configuration.