Wren Associates ip-eg12 Instruccion De Instalación

 
 
 

PROPERTY OF WREN 

Page 2 of 3 

7L247 REV-B 10-09-2006 

 
 

124 WREN PARKWAY • JEFFERSON CITY, MO 65109 • TOLL FREE (800) 881-2249 • FAX (877) 893-2317 

 

 

6.  The EG8 is designed to be operated by a 24VAC power source 

1.  Remove the dome. 

2.  Disconnect the PTZ camera from its base by pushing in and twisting 

counter clockwise.  Set aside. 

3.  Apply thread sealant (included) to the 1½” NPT pipe threads or 

approved mount. This procedure will prevent moisture ingress through 
the threads. [Figure 2] 

 

threads will permit water to enter the housing 
and may damage the internal equipment. 

4.  Install EG8 assembly on 1½” NPT pipe or mount by rotating counter-

clockwise until threads are fully engaged. 

5.  Detach the camera mounting plate from the housing and allow it to be 

suspended by tether. 

6.  Remove foam dust cap and route CAT5 and power cables into the housing. 

7.  Connect 24VAC to the input terminals on circuit board marked “+IN-.”  

[Figure 3] 

8.  Insert end of CAT5 into the RJ45 jack in the IP encoder module. [Figure 

4] 

9.  Push extra wire length up through housing flange and re-install the foam 

dust cap in the cable entrance of the housing. 

10.  Reinstall and tighten the screws holding the camera mounting plate. 

11.  Reconnect the PTZ camera to its base on the camera mounting plate by 

pressing onto the plate and turning clockwise. 

12.  Reinstall dome assembly and tighten screws to ensure a proper seal with 

the dome gasket. 

 

• 

Input Voltage = 24VAC ± 10%

• 

Power = 2.5A @ 24VAC (w/ heater on)

• 

Blower = 4.7 CFM (2.2 watts) (continuous operation)

• 

Heater = 40 watts

 

(consult factory for color and style options) 

• 

Curved Wall Mount  

HM11xx

• 

Pole Mount 

 

HM12xx (requires HM11xx)

• 

Corner Mount   

HM13xx (requires HM11xx)

• 

Roof (Parapet) Mount 

HM14xx (requires HM11xx)

 

FIGURE 3 

FIGURE 4 

FIGURE 1 

FIGURE 2