3com 5500-ei pwr Instruccion De Instalación
1-5
To do…
Use the command…
Remarks
group
mirroring-group group-id
monitor-port
monitor-port
When configuring local port mirroring, note that:
z
You need to configure the source and destination ports for the local port mirroring to
take effect.
z
The source port and the destination port cannot be a fabric port or a member port of an
existing mirroring group; besides, the destination port cannot be a member port of an
aggregation group or a port enabled with LACP or STP.
Configuring Remote Port Mirroring
A Switch 5500-EI can serve as a source switch, an intermediate switch, or a destination
switch in a remote port mirroring networking environment.
Configuration on a switch acting as a source switch
1) Configuration
prerequisites
z
The source port, the reflector port, and the remote-probe VLAN are determined.
z
Layer 2 connectivity is ensured between the source and destination switches over the
remote-probe VLAN.
z
The direction of the packets to be monitored is determined.
2) Configuration
procedure
Follow these steps to perform configurations on the source switch:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Create a VLAN and enter
the VLAN view
the VLAN view
vlan vlan-id
vlan-id is the ID of the
remote-probe VLAN.
remote-probe VLAN.
Configure the current VLAN
as the remote-probe VLAN
as the remote-probe VLAN
remote-probe vlan enable
Required
Return to system view
quit
—
Enter the view of the
Ethernet port that connects
to the intermediate switch
or destination switch
Ethernet port that connects
to the intermediate switch
or destination switch
interface interface-type
interface-number
interface-number
—