3com 5500-ei pwr Instruccion De Instalación

 

1-27 

z 

After RSA key pairs are generated, the display rsa local-key-pair public command displays 

two public keys (the host public key and server public key) when the switch is working in 

SSH1-compatible mode, but only one public key (the host public key) when the switch is 

working in SSH2 mode. 

z 

The results of the display rsa local-key-pair public command or the public key converted with 

the SSHKEY tool contains no information such as the authentication type, so they cannot be 

directly used as parameters in the public-key peer command. For the same reason, neither can 

the results of the display public-key local rsa public command be used in the rsa 

peer-public-key command directly. 

 

As shown in

 Figure 1-11

, establish an SSH connection between the host (SSH Client) and the switch 

(SSH Server) for secure data exchange. The host runs SSH2.0 client software. Password 

authentication is required. 

Figure 1-11 Switch acts as server for local password authentication 

 

 

z 

Configure the SSH server 

# Create a VLAN interface on the switch and assign an IP address, which the SSH client will use as the 

destination for SSH connection. 

<Switch> system-view 

[Switch] interface vlan-interface 1 

[Switch-Vlan-interface1] ip address 192.168.0.1 255.255.255.0 

[Switch-Vlan-interface1] quit