3com 5500-ei pwr Guía De Referencia

 

1-20 

lldp hold-multiplier value 

undo lldp hold-multiplier 

System view 

value: TTL multiplier, in the range 2 to 10. 

Use the lldp hold-multiplier command to set the TTL multiplier. 

Use the undo lldp hold-multiplier command to restore the default. 

The TTL multiplier defaults to 4. 

You can set the TTL of the local device information by configuring the TTL multiplier.  

The TTL of the information about a device is determined by the following expression: 

TTL multiplier × LLDPDU sending interval 

You can set the TTL of the local device information by configuring the TTL multiplier. Note that the TTL 

can be up to 65535 seconds. TTLs longer than it will be rounded off to 65535 seconds. 

To enable local device information to be updated on neighboring devices before being aged out, make 

sure the interval to send LLDPDUs is shorter than the TTL of the local device information. 

# Set the TTL multiplier to 6. 

<Sysname> system-view 

[Sysname] lldp hold-multiplier 6 

lldp management-address-tlv [ ip-address ] 

undo lldp management-address-tlv 

Ethernet interface view 

ip-address: Management address to be set. 

Use the lldp management-address-tlv command to enable the management address sending. This 

command also sets the management address.