3com 7000 Manual Suplementario
160
C
HAPTER
6: ILMI C
ONFIGURATION
Add ATM Address to
Port
Adds an ATM address to the list of registered ATM addresses at a port.
Enter the port number and ATM address. Use this command, for
example, for IISP or E-IISP manual port configuration or for devices that
do not support IIMI.
Enter the port number and ATM address. Use this command, for
example, for IISP or E-IISP manual port configuration or for devices that
do not support IIMI.
Perform the command Save ATM Addresses to Flash (“Save ATM
Addresses to Flash” on page 162) before the next reboot to ensure that
your changes are saved.
Addresses to Flash” on page 162) before the next reboot to ensure that
your changes are saved.
Command Actions
Command Result
Example
Enter:
3 4 2 2 3.1
47.0.0.0.0.0.3c.0.0.b*.*.* .*.*.*.*.*.*.*.*
The following message is displayed.
Address already exists on port <6.1>, Use it again? (y/n) n
Enter the menu sequence:
(3) CON: Connections
(4) S&C: Setup and Config Conns
(2) STP: Atm address setup
(2) ADD: Add ATM address
Enter a parameter at the prompt
Parameter
Format or Range
Port ID
slot.port
ATM address
19 bytes—When fewer, end with '.*'
Direct access sequence:
3 4 2 2
[parameters]
System action taken:
The specified ATM address is added to specified port.
The change is not saved to flash memory.
The change is not saved to flash memory.
System message display:
Address was set for port.