3com 7000 Manual Suplementario
20
A
BOUT
T
HIS
G
UIDE
Command
Description
Chapters 2 through 13 provide information about all the LMA
commands. For each command, a standard format is used to describe the
command. A sample command description is presented in Figure 1
below:
commands. For each command, a standard format is used to describe the
command. A sample command description is presented in Figure 1
below:
Figure 1 LMA Command Description Format
As shown in Figure 1, the command description presented in the manual
is divided into four sections:
is divided into four sections:
Command Actions
Command Result
Enter menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(1) PAS: Password setup
(1) REA: Set Read-access Password
(1) SET: Switch setup
(1) PAS: Password setup
(1) REA: Set Read-access Password
Enter parameter at prompt
Parameter
Format or Range
New password
Up to eight alphanumeric characters
New password again
Direct access sequence:
1 1 1 1
[parameters]
System action:
The read-access password is updated.
A
B
C
D
Table 3 Command Description Sections
Key
Section
Description
A
Menu sequence
The menu options that need to be selected in order
to execute the command. All the levels/sublevels to
be followed are presented.
to execute the command. All the levels/sublevels to
be followed are presented.
B
Parameters
The parameters to be entered after the menu
sequence and the format they must be entered. If no
parameters are necessary, this section does not
appear in the command description.
sequence and the format they must be entered. If no
parameters are necessary, this section does not
appear in the command description.