3com 7000 Manual Suplementario
230
C
HAPTER
7: C
ONFIGURING
V
IRTUAL
C
HANNELS
Remove VP Tunnel
from Port
Removes a VP tunnel from a port of the CoreBuilder 7000 family ATM
switch. Specify the port and VPI number. For more information, see “VP Tunneling” on page 5-101.
switch. Specify the port and VPI number. For more information, see “VP Tunneling” on page 5-101.
Command Actions
Command Result
See Table 34 for definitions of the command parameters.
Example
Enter:
1 1 9 3 3 3.2 3
The following message is displayed:
Tunnel is set to DISABLED.
The VP tunnel with VPI=3 is removed from port 3.2.
Enter the menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(9) VPT: VP Tunneling Setup
(3) TUN: Tunnels Setup
(3) DTN: Disable Tunnel on Port
Enter a parameter at the prompt
Parameter
Format or Range
Port ID
slot.port
VPI Value
0
through
7
Direct access sequence:
1 1 9 3 3
[parameters]
System action taken:
A VP tunnel is removed from a port. The change takes
place immediately.
place immediately.
System message display:
Tunnel is set to DISABLED.