3com 7000 Manual Suplementario
234
C
HAPTER
8: V
IEWING
S
TATISTICS
Physical Statistics
The following commands allow you to display physical statistics.
■
■
For more information on physical statistics, see “Traffic Statistics” on page 134 in the Operations Guide.
Display Physical Layer
Statistics
Displays the physical layer statistics for a specified port.
When the link status LED is lit, the physical layer statistics displayed by this
command are invalid. This condition indicates a synchronization problem
on the Physical Layer.
command are invalid. This condition indicates a synchronization problem
on the Physical Layer.
Command Actions
Command Result
Example
Enter:
4 2 3.2
The physical statistics are displayed for port <3.2>.
Enter the menu sequence:
(4) STS: Statistics
(2) PHY: Physical layer
Enter a parameter at the prompt
Parameter
Format or Range
Port ID
slot.port
Direct access sequence:
4 2
System action taken:
Physical statistics for the switch are displayed.
System message display:
Information is displayed as shown in the example
below.
below.