3com 7000 Manual Suplementario
384
C
HAPTER
13: C
ONFIGURING
AND
M
ANAGING
PNNI (F
OR
THE
E
XTENDED
V
ERSION
O
NLY
)
Set Default ATM
Address
Sets the last six bytes (ESI - End System Identifier) of the ATM address of
the current node to the default ATM address value. A change to the
default ATM address takes place after the next reboot.
the current node to the default ATM address value. A change to the
default ATM address takes place after the next reboot.
Command Actions
Command Result
Example
Enter:
1 1 10 4 3 3 2 2
The following message is displayed:
ESI (6 bytes) of ATM ADDRESS was set to DEFAULT:
47.00.00.00.00.00.3C.00.00.00.00.00.00.00.C0.DA.60.27.F6.FF
The last six bytes of the ATM address are set to their default values.
In the example above, for clarity, the ESI of the ATM address is
underlined.
underlined.
Enter menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(3) CHR: Characteristics
(2) ADD: ATM Address
(2) SDF: Set default ATM Address
Direct access sequence:
1 1 10 4 3 3 2 2
System action taken:
The default ATM address is displayed.
System message display:
ESI (6 bytes) of ATM ADDRESS was set to
DEFAULT: <default address>