3com 7000 Manual Suplementario
Setting the Timers
403
Set Retransmit
Interval
Sets the retransmit interval. The retransmit interval is the time after which
unacknowledged PTSEs will be retransmitted. A change to the retransmit
interval takes place after the next reboot.
unacknowledged PTSEs will be retransmitted. A change to the retransmit
interval takes place after the next reboot.
Command Actions
Command Result
Example
Enter:
1 1 10 4 3 4 7 1
The following message is displayed:
Default Value is 5, new value is 1
Press ENTER to continue...
Enter menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(4) TIM: Timers
(7) RTI: Retransmit Interval
Enter a parameter at the prompt
Parameter
Format or Range
interval
1 - 60000 seconds
Direct access sequence:
1 1 10 4 3 4 7
[parameters]
System action taken:
The retransmit interval is displayed and is updated to
its new value.
its new value.
System message display:
Default value is <x>, new value is <y>