3com 7000 Manual Suplementario
406
C
HAPTER
13: C
ONFIGURING
AND
M
ANAGING
PNNI (F
OR
THE
E
XTENDED
V
ERSION
O
NLY
)
Set AvCR Minimum
Threshold (%)
Sets the AvCR minimum threshold percentage. The AvCR minimum
threshold percentage is the minimum percentage change in bandwidth,
after which a node will inform its neighbors of a significant change via a
PTSE. For more information on PTSE regeneration, see “PTSE” on page 78 in the Operations Guide. A change to the AvCR minimum threshold
percentage value takes place after the next reboot.
threshold percentage is the minimum percentage change in bandwidth,
after which a node will inform its neighbors of a significant change via a
PTSE. For more information on PTSE regeneration, see “PTSE” on page 78 in the Operations Guide. A change to the AvCR minimum threshold
percentage value takes place after the next reboot.
Command Actions
Command Result
Example
Enter:
1 1 10 4 3 4 10 15
The following message is displayed:
Default Value is 3, new value is 15
Press ENTER to continue...
Enter menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(4) TIM: Timers
(10) AMT: AvCR Minimum
Threshold(%)
Enter a parameter at the prompt
Parameter
Format or Range
percentage
1 - 99%
Direct access sequence:
1 1 10 4 3 4 10
[parameters]
System action taken:
The AvCR minimum threshold is displayed and is
updated to its new value.
updated to its new value.
System message display:
Default value is <x>, new value is <y>