3com 7000 Manual Suplementario
90
C
HAPTER
4: C
ONFIGURING
AND
M
ANAGING
THE
S
WITCH
M
ODULES
Reset All
Configuration
Parameters Except IP
Address
Resets all configuration parameters for the CoreBuilder 7000 family ATM
switch to their factory default settings except for the IP address. Use this
command when you need to retain Telnet connectivity while resetting the
parameters.
switch to their factory default settings except for the IP address. Use this
command when you need to retain Telnet connectivity while resetting the
parameters.
See Table 15 for a list of factory default values for configuration
parameters.
parameters.
It is recommended to perform this command when the switch is off-line.
After executing this command the switch is automatically rebooted. The
switch is configured after rebooting.
switch is configured after rebooting.
Command Actions
Command Result
Example
Enter:
1 2
3
The following prompt is displayed:
This will reset all configuration to factory defaults, except
IP configuration. Then the switch will reboot.
Are you sure? (Y/N)? Y
Enter
Y
to confirm,
N
to cancel reset.
Enter the menu sequence:
(1) SYS: Platform config
(2) FLS: Flash setup
(3) REI: Reset all configs except IP
Enter a parameter at the prompt
Parameter
Format or Range
Continue prompt
y
or
n
Direct access sequence:
1 2 3
System action taken:
All configuration parameters except for the IP address
are reset to their factory default values.
are reset to their factory default values.
System message display:
All configuration parameters are reset
to their factory values.