3com 7000 Manual Suplementario
Resetting Configuration Parameters
87
Reset All
Configuration
Parameters
Resets all configuration parameters for the CoreBuilder 7000 family ATM
switch in flash memory to their factory default settings.
switch in flash memory to their factory default settings.
If you need to retain Telnet connectivity while resetting the parameters,
use the command Reset All Configuration Parameters Except IP Address
instead (see “Reset All Configuration Parameters Except IP Address” on
page 90).
use the command Reset All Configuration Parameters Except IP Address
instead (see “Reset All Configuration Parameters Except IP Address” on
page 90).
Table 15 shows the factory default values of the configuration
parameters.
parameters.
Table 14 Configuration Parameter Groups
Parameter
Description
Block ID
The id of the flash block in which the region is located.
Group name
Flash regions.
Group ID
ID for the region.
Maximum length
Maximum length in bytes.
Actual length
Actual length in bytes.
No. of rec.
Number of records.
Table 15 Configuration Parameter Default Values
Parameter
Set to
General
Signaling Version
UNI 4.0
Signaling Timers
5 X Standard Defaults (for example, timer
resolution = 500)
resolution = 500)
EFCI threshold
50% congestion
Max Hop Count
7
ATM Interface Type
UNI
ILMI
ILMI version
4.0
Auto-Configuration
Enabled
Auto-Discovery
Enabled
COA
Disabled
ILMI Timers
Default
LANE Services
LANE Services (LECS & LES\BUS)
Disabled