3com 7000 Manual Suplementario
98
C
HAPTER
4: C
ONFIGURING
AND
M
ANAGING
THE
S
WITCH
M
ODULES
EFCI Threshold
The following commands allow you to configure the EFCI threshold.
■
■
For more information about EFCI, see “Traffic Management” on page 135 in the Operations Guide.
The EFCI LMA commands are only relevant to the CoreBuilder 7000
switch. For the CoreBuilder 7000HD switch, the EFCI threshold mode is
not configurable and is always set to 50%.
switch. For the CoreBuilder 7000HD switch, the EFCI threshold mode is
not configurable and is always set to 50%.
Display EFCI
Threshold
Displays the EFCI Threshold of the CoreBuilder 7000 switch.
Command Actions
Command Result
Example
Enter:
1 1 7 1
The following message is displayed:
EFCI threshold mode is: 50% full.
Enter the menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(7) FCI: EFCI threshold setup
(1) GET: Get EFCI threshold
Direct access sequence:
1 1 7 1
System action taken:
The EFCI Threshold of the CoreBuilder 7000 family
ATM switch is displayed.
ATM switch is displayed.
System message display:
EFCI threshold mode is: n% full.