3com 140m Guía Del Usuario
2-8
C
HAPTER
2: C
REATING
Y
OUR
N
ETWORK
10BASE-T and 100BASE-TX cables are very easy to
use. To connect a cable, simply slot the connector into
the relevant RJ45 port. When the connector is fully in,
its latch locks it in place. To disconnect the cable,
push the connector’s latch in and remove it.
use. To connect a cable, simply slot the connector into
the relevant RJ45 port. When the connector is fully in,
its latch locks it in place. To disconnect the cable,
push the connector’s latch in and remove it.
Your switch detects all port connections, so you can
start using your network immediately. When you need
more ports, simply add OfficeConnect hubs.
start using your network immediately. When you need
more ports, simply add OfficeConnect hubs.
Connecting OfficeConnect Hubs to Your
Switch
Switch
You can increase the number of workstations that can
connect to your network by adding OfficeConnect
hubs.
connect to your network by adding OfficeConnect
hubs.
Connecting 10BASE-T Hubs
You can connect 10BASE-T OfficeConnect hubs to
your switch using the following method, for each
hub:
your switch using the following method, for each
hub:
1
Connect the MDI/MDIX port (port 8 in this example)
of the 10BASE-T hub to any of the OfficeConnect
switch’s 10BASE-T ports, as shown in
of the 10BASE-T hub to any of the OfficeConnect
switch’s 10BASE-T ports, as shown in
.
2
Set the MDI/MDIX switch on the 10BASE-T hub to
MDI (in).
MDI (in).
Figure 2-4 Correct Connections for a 10BASE-T Hub