3com 140m Guía Del Usuario
5-8
C
HAPTER
5: U
SING
THE
C
OMMAND
L
INE
I
NTERFACE
4
You are prompted for a default router address:
Enter default gateway [0.0.0.0]:
Enter a default router address or press [Return] if it’s
not needed.
not needed.
5
You are prompted for a SLIP address:
Enter SLIP address [192.168.101.1]:
Enter a SLIP address or press [Return] if it’s not
needed.
needed.
6
Finally, you are prompted for a SLIP subnet mask:
Enter SLIP subnet mask [255.255.255.0]:
Enter a SLIP subnet mask or press [Return] if it’s not
needed.
needed.
Viewing the Configuration
You can use the display command to show current
configuration information for your switch.
configuration information for your switch.
Displaying the Switch Configuration
From the top-level menu, enter:
system display
The CLI shows information similar to this example:
3Com OfficeConnect Switch 140M, SW Version:1.00
Unit Name
Unit Name
: Marketing
Location
: Top floor
Contact
: James
Time since reset
: 2 Hrs 3 Mins 10 Sec
Operational Version
: 1.00
Hardware Version
: 1.00
Boot Version
: 1.00
MAC Address
: 08004e2b2d12
This information is in the switch’s MIB (Management
Information Base) and is read-only. You can change
the Unit Name, Location and Contact using the web
interface.
Information Base) and is read-only. You can change
the Unit Name, Location and Contact using the web
interface.
If a problem occurs and you need advice from your
support representative, you may be asked for some of
the information shown on this screen.
support representative, you may be asked for some of
the information shown on this screen.