3com 140m Guía Del Usuario
Commands
5-9
Displaying the IP Configuration
At the prompt, enter the command:
ip interface display
The CLI displays the IP address, subnet mask, default
router address, SLIP address and SLIP subnet mask for
the switch. For information on changing these values,
refer to
router address, SLIP address and SLIP subnet mask for
the switch. For information on changing these values,
refer to
Resetting the Switch
Resetting the switch simulates powering off and
powering on the switch. You may want to do this if
you want to:
powering on the switch. You may want to do this if
you want to:
■
Apply any changes made to the switch’s IP, SLIP
and default router information.
and default router information.
■
Remove all of the non-permanent addresses from
the switch database.
the switch database.
■
Reset the switch’s statistics counters.
CAUTION: Performing a reset may cause some of
the data being transmitted over the network to be
lost.
the data being transmitted over the network to be
lost.
To reset the switch:
1
At the top-level menu, enter:
system reset
2
The CLI asks you to confirm the reset. Enter
y
if you
wish to proceed, or
n
if you want to stop the reset.
During a reset, you are unable to communicate with
the switch. After the reset, type [Return][Return] to
restore the communication (if required). The reset
process takes about 10 seconds.
the switch. After the reset, type [Return][Return] to
restore the communication (if required). The reset
process takes about 10 seconds.