3com S7906E Instruccion De Instalación
1-15
To do…
Use the command…
Remarks
Enable global MPLS TE
mpls te
Required
Disabled by default
Disabled by default
Exit to system view
quit
––
Enter the interface view of an
MPLS TE link
MPLS TE link
interface interface-type
interface-number
interface-number
––
Enable interface MPLS TE
mpls te
Required
Disabled by default
Disabled by default
Exit to system view
quit
––
Create a tunnel interface and
enter its view
enter its view
interface tunnel
tunnel-number
tunnel-number
Required
Assign an IP address to the
tunnel interface
tunnel interface
ip address ip-address
netmask
netmask
Required
Set the tunnel protocol to MPLS
TE
TE
tunnel-protocol
mpls te
Required
Configure the destination
address of the tunnel
address of the tunnel
destination ip-address
Required
Configure the tunnel ID of the
tunnel
tunnel
mpls te tunnel-id
tunnel-id
Required
Submit the current tunnel
configuration
configuration
mpls te commit
Required
z
Depending on the MPLS TE signaling protocol a tunnel uses, the basic capabilities you configured
in this section may be inadequate for the tunnel to work and you may need to make extra
configurations.
in this section may be inadequate for the tunnel to work and you may need to make extra
configurations.
z
For information about tunnel interfaces, refer to Tunneling Configuration in the IP Services Volume.
Creating MPLS TE Tunnel over Static CR-LSP
Creating MPLS TE tunnels over static CR-LSPs does not involve configuration of tunnel constraints or
the issue of IGP TE extension or CSPF. What you need to do is to create a static CR-LSP and a TE
tunnel using static signaling and then associate them.
the issue of IGP TE extension or CSPF. What you need to do is to create a static CR-LSP and a TE
tunnel using static signaling and then associate them.
Despite its ease of configuration, the application of MPLS TE tunnels over static CR-LSPs is restricted
because they do not accept bandwidth constraints and cannot dynamically adapt to network changes.
because they do not accept bandwidth constraints and cannot dynamically adapt to network changes.
Static CR-LSPs are special static LSPs. They share the same constraints and use the same label
space.
space.
Configuration Prerequisites
Before making the configuration, do the following:
z
Configure static routing or an IGP protocol to make sure that all LSRs are reachable.