3com S7906E Guía De Referencia

 

1-11 

Use the igmp-snooping general-query source-ip command to configure the source address of IGMP 

general queries.  

Use the undo igmp-snooping general-query source-ip command to restore the default 

configuration.  

By default, the source IP address of IGMP general queries is 0.0.0.0.  

This command takes effect only if IGMP Snooping is enabled in the VLAN.  

Related commands: igmp-snooping enable. 

# In VLAN 2, enable IGMP Snooping and specify 10.1.1.1 as the source IP address of IGMP general 

queries.  

<Sysname> system-view 

[Sysname] igmp-snooping 

[Sysname-igmp-snooping] qui 

[Sysname] vlan 2 

[Sysname-vlan2] igmp-snooping enable 

[Sysname-vlan2] igmp-snooping general-query source-ip 10.1.1.1 

igmp-snooping group-limit limit [ vlan vlan-list ] 

undo igmp-snooping group-limit [ vlan vlan-list ] 

Ethernet interface view, Layer 2 aggregate interface view, port group view 

2: System level 

limit: Maximum number of multicast groups that can be joined on a port, in the range 1 to 1000.  

vlan vlan-list: Defines one or multiple VLANs. You can provide up to 10 VLAN lists, by each of which 

you can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to 

end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of a 

VLAN ID is 1 to 4094.  

Use the igmp-snooping group-limit command to configure the maximum number of multicast groups 

that can be joined on a port.  

Use the undo igmp-snooping group-limit command to restore the default setting.  

The default setting depends on the specific product model.  

Note that: