3com S7906E Guía De Referencia

 

1-27 

z 

Do not configure both the dsap-id and ssap-id arguments in the protocol-vlan command as 0xe0 

or 0xff when configuring the user-defined template for llc encapsulation. Otherwise, the 

encapsulation format of the matching packets will be the same as that of the ipx llc or ipx raw 

packets respectively. When either of the dsap-id and ssap-id arguments is configured, the system 

assigns aa to the other argument. 

z 

When you use the mode keyword to configure a user-defined protocol template, do not set etype-id 

in ethernetii etype etype-id to 0x0800, 0x8137, 0x809b, or 0x86dd. Otherwise, the encapsulation 

format of the matching packets will be the same as that of the IPv4, IPX, AppleTalk, and IPv6 

packets respectively. 

 

Use the protocol-vlan command to configure the VLAN as a protocol based VLAN and configure the 

protocol template for the VLAN.  

Use the undo protocol-vlan command to remove the configured protocol template. 

By default, no VLAN is bound with any protocol template. 

Related commands: display protocol-vlan vlan. 

 

Do not configure a VLAN as both a protocol-based VLAN and a voice VLAN. 

 

# Configure VLAN 3 as an IPv4 based VLAN. 

<Sysname> system-view 

[Sysname] vlan 3 

[Sysname-vlan3] protocol-vlan ipv4 

 

Because IP depends on ARP for address resolution in Ethernet, you are recommended to configure the 

IP and ARP templates in the same VLAN and associate them with the same port to prevent 

communication failure.  

 

# Create an ARP protocol template for VLAN 3 (ARP code is 0x0806) to make VLAN 3 transmit ARP 

packets. 

z 

To use Ethernet encapsulation, use the command: 

[Sysname-vlan3] protocol-vlan mode ethernetii etype 0806