3com S7906E Guía De Referencia

 

1-12 

z 

The Track object specified in this command can be nonexistent. You can use the vrrp vrid track 

command to specify a Track object, and then create the Track object using the track command. 

 

For details of the Track object, refer to Track Configuration in the System Volume. 

 

# Configure to monitor Track object 1, making the priority of VRRP group 1 on VLAN-interface 2 

decrease by 50 when Track object 1 turns to negative. 

<Sysname> system-view 

[Sysname] interface vlan-interface 2 

[Sysname-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.1 

[Sysname-Vlan-interface2] vrrp vrid 1 track 1 reduced 50 

vrrp vrid virtual-router-id track interface interface-type interface-number [ reduced priority-reduced ] 

undo vrrp vrid virtual-router-id track [ interface interface-type interface-number ] 

Interface view 

2: System level 

virtual-router-id: VRRP group number, in the range 1 to 255. 

interface interface-type interface-number: Specifies an interface to be tracked by its type and number. 

reduced priority-reduced: Value by which the priority decrements. priority-reduced ranges from 1 to 255 

and defaults to 10. 

Use the vrrp vrid track interface command to configure to track the specified interface. 

Use the undo vrrp vrid track interface command to disable tracking the specified interface. 

By default, no interface is tracked. 

Note that: 

z 

Before executing the command, create a VRRP group on an interface and configure the virtual IP 

address of the VRRP group. 

z 

When the switch is the owner of the IP address, you cannot perform the configuration. 

z 

When the status of the tracked interface turns from down to up, the corresponding switch restores 

its priority automatically.