3com S7906E Guía De Referencia

 

1-14 

[Sysname-rrpp-domain1] ring 20 node-mode transit primary-port gigabitethernet 3/0/1 

secondary-port gigabitethernet 3/0/2 level 1 

# Specify the device as the edge node of primary ring 20 in RRPP domain 1, and GigabitEthernet 3/0/1 

as the edge port. 

<Sysname> system-view 

[Sysname] rrpp domain 1 

[Sysname-rrpp-domain1] control-vlan 100 

[Sysname-rrpp-domain1] protect-vlan reference-instance 0 1 2 

[Sysname-rrpp-domain1] ring 20 node-mode edge edge-port gigabitethernet 3/0/1 

# Specify the device as the assistant edge node of primary ring 20 in RRPP domain 1, and 

GigabitEthernet 3/0/1 as the edge port. 

<Sysname> system-view 

[Sysname] rrpp domain 1 

[Sysname-rrpp-domain1] control-vlan 100 

[Sysname-rrpp-domain1] protect-vlan reference-instance 0 1 2 

[Sysname-rrpp-domain1] ring 20 node-mode assistant-edge edge-port gigabitethernet 3/0/1 

ring ring-id enable 

undo ring ring-id enable 

RRPP domain view 

2: System level 

ring-id: RRPP ring ID, in the range 1 to 64. 

Use the ring enable command to enable the RRPP ring.  

Use the undo ring enable command to disable the RRPP ring. 

By default, the RRPP ring is disabled. 

Note that: 

z 

To enable subrings, you must first enable the primary ring before enabling subrings.  

z 

You must first disable all the subrings in the RRPP domain and then disable the primary ring.  

z 

To activate the RRPP domain, RRPP protocol and the RRPP ring must be enabled simultaneously. 

Related commands: rrpp enable. 

# Enable RRPP ring 10 in RRPP domain 1. 

<Sysname> system-view