3com S7906E Guía De Referencia

 

1-2 

# Set the interface VLAN-interface 100 (193.101.1.1) of Sysname 1 and the interface VLAN-interface 

100 (192.100.1.1) of Sysname 2 as the source and destination interfaces of a tunnel between the two 

devices, respectively. 

<Sysname1> system-view 

[Sysname1] interface tunnel 2/0/0 

[Sysname1-Tunnel2/0/0] source 193.101.1.1 

[Sysname1-Tunnel2/0/0] destination 192.100.1.1 

<Sysname2> system-view 

[Sysname2] interface tunnel 2/0/1 

[Sysname2-Tunnel2/0/1] source 192.100.1.1 

[Sysname2-Tunnel2/0/1] destination 193.101.1.1 

display interface tunnel [ number ] 

Any view 

1: Monitor level 

number: Tunnel interface number. If the number argument is not specified, the information of all tunnel 

interfaces will be displayed. 

Use the display interface tunnel command to display related information of a specified tunnel 

interface, such as source address, destination address, and encapsulation mode. 

Related commands: interface tunnel, source, destination, tunnel-protocol. 

# Display the information of the interface tunnel 2/0/0. 

<Sysname> display interface tunnel 2/0/0 

Tunnel2/0/0 current state: UP 

Line protocol current state: UP 

Description: Tunnel2/0/0 Interface 

The Maximum Transmit Unit is 1476 

Internet Address is 10.1.2.1/24 Primary 

Encapsulation is TUNNEL, service-loopback-group ID is 1. 

Tunnel source 192.13.2.1, destination 192.13.2.2 

Tunnel protocol/transport IPv6/IP 

Output queue : (Urgent queuing : Size/Length/Discards)  0/100/0 

Output queue : (Protocol queuing : Size/Length/Discards)  0/500/0