3com 3031 Instruccion De Instalación
1002
C
HAPTER
72: MPLS Q
O
S
Configuring MPLS PQ
Complete these two steps to configure MPLS PQ: First, configure priority list
according to MPLS EXP. Second, apply the priority list on the interface. For more
information, refer to “Priority Queuing Configuration” in Chapter 68
according to MPLS EXP. Second, apply the priority list on the interface. For more
information, refer to “Priority Queuing Configuration” in Chapter 68
Configuring Priority List according to MPLS EXP
Classify the packets according to MPLS EXP value and enable them to enter
different queues.
different queues.
Perform the following in the System View.
Applying PLQ on the Interface
Apply a group of priority-lists on the interface; to use this command repeatedly
will set a new priority-list for the same interface.
will set a new priority-list for the same interface.
Perform the following configuration under interface view.
Not PQ but FIFO is employed on the interface by default.
Configuring MPLS CQ
Complete these two steps to configure MPLS CQ: First, configure priority list
according to MPLS EXP. Second, apply the priority list on the interface. For more
information, refer to “Custom Queueing Configuration” in Chapter 68.
according to MPLS EXP. Second, apply the priority list on the interface. For more
information, refer to “Custom Queueing Configuration” in Chapter 68.
Configuring custom-list according to MPLS EXP
Configure custom-list according to MPLS EXP and enable packets to enter
different queues.
different queues.
Perform the following in the System View.l
Table 1083 Configuring priority list according to network protocol
Operation
Command
Configure priority list according to
network protocol
network protocol
qos pql pql-index protocol mpls-exp
{
mpls-experimental-value
}
queue { top |
middle | normal | bottom
}
Delete corresponding classification
rule of a specified group
rule of a specified group
undo qos pql pql-index protocol mpls-exp
{
mpls-experimental-value
}
queue { top |
middle | normal | bottom
}
Table 1084 Applying priority-list group on the interface
Operation
Command
Apply priority-list group on the
interface
interface
qos pq pql pql-index
Cancel PQ setting on the interface
undo qos pq
Table 1085 Configuring custom-list according to network protocol
Operation
Command
Configure custom-list according to
MPLS EXP
MPLS EXP
qos cql cql-index protocol mpls-exp
{
experimental-number
}
queue queue-number
Delete the corresponding
classification rule
classification rule
undo qos cql cql-index protocol mpls-exp
{
experimental-number
}
queue
queue-number