3com 3031 Instruccion De Instalación
User Interface Configuration Procedure
69
For example, set
modem
auto-answer on the
aux
port.
[3Com-ui-aux0]modem auto-answer
Configuring the
Redirection Function
The send command
The
send
command is used for the message transmission between user interfaces.
Perform the following in the User View.
The auto-execute command
You should be aware of the following restrictions before using the
auto-execute
command
command:
■
CON does not support
auto-execute
command.
■
If there is only AUX but no CON on a router (AUX and CON shares the same
port), the AUX will not support
port), the AUX will not support
auto-execute
command
as well.
■
These constraints do not apply to other types of user interfaces.
When a user logs on, some command configured using
auto-execute
command
on the terminal will automatically be executed. The user line will be disconnected
automatically once the execution of the command is finished.
automatically once the execution of the command is finished.
A common approach is to configure the Telnet command using the
auto-execute
command
command on the terminal so that the user may automatically connect to
the specified host.
CAUTION: You should use this command with cautions because it will probably
make you unable to make the regular configurations for the system via the
terminal line to which the command is applied. Before configuring the
make you unable to make the regular configurations for the system via the
terminal line to which the command is applied. Before configuring the
auto-execute command
command and saving the configuration (by executing the
save
command), you should make sure that you can access the system to remove
the configuration by other means.
Perform the following in the User Interface View.
Restore the default time interval that the system
waits for the CD_UP signal after receiving the RING
signal
waits for the CD_UP signal after receiving the RING
signal
undo modem timer answer
Set the answer mode to auto-answer
modem auto-answer
Set the answer mode to manual answer
undo modem auto-answer
Enable the modem to dial in and dial out
modem [ call-in | both ]
Disable the modem to dial in or dial out
undo modem [ call-in | both ]
Table 65 Making modem configurations
Table 66 Sending messages between user interfaces
Operation
Command
Send message to user interfaces
send { all | number | type-name number }