3com 3031 Instruccion De Instalación
DCC Configuration
1053
2 Implement the ISDN caller identification callback server in the Resource-Shared
DCC
Perform the following configuration in dialer interface view.
By default, callback according to ISDN caller identification is not configured.
A dialer number should be configured on the dialer interface at server end
through the
through the
dialer number
command, but it is not required to be exactly the
same as the dial-in dialer number.
Configuring Special DCC
Functions
Configuring ISDN leased line
This function can only be used with Circular DCC and must be implemented after
Circular DCC has been configured. ISDN leased line application is fulfilled through
establishing semi permanent ISDN MP connections. Such application requires that
a leased line has been established on the PBX of the telecommunication service
provider and has been connected to the remote device.
Circular DCC has been configured. ISDN leased line application is fulfilled through
establishing semi permanent ISDN MP connections. Such application requires that
a leased line has been established on the PBX of the telecommunication service
provider and has been connected to the remote device.
Perform the following configuration in dial interface (ISDN PRI interface) view.
By default, no B channel is configured for ISDN leased line connection.
Configuring auto-dial
This function can only be used with Circular DCC. With a Circular DCC, after the
router is started, the DCC will automatically attempt to dial the remote end of the
connection without requiring a triggering packet. If a normal connection cannot
be established with the remote end, DCC will automatically retry at a certain
interval. Compared with the auto-dial DCC triggered by packets, such connections
do not automatically disconnect due to timeout. In other words, the
router is started, the DCC will automatically attempt to dial the remote end of the
connection without requiring a triggering packet. If a normal connection cannot
be established with the remote end, DCC will automatically retry at a certain
interval. Compared with the auto-dial DCC triggered by packets, such connections
do not automatically disconnect due to timeout. In other words, the
dialer
timer idle
command does not take effect on auto-dial.
Configure the dial number for
calling a remote end
calling a remote end
dialer number [ dial-number ]
Table 1132 Implementing ISDN caller identification callback (client configuration) in
Resource-Shared DCC
Resource-Shared DCC
Table 1133 Implementing ISDN caller identification callback (server configuration) in
Resource-Shared DCC
Resource-Shared DCC
Operation
Command
Configure the local end to
implement ISDN callback according
to the ISDN caller identification
implement ISDN callback according
to the ISDN caller identification
dialer call-in remote-number [ callback ]
Disable the local end to implement
ISDN callback according to the ISDN
caller identification
ISDN callback according to the ISDN
caller identification
undo dialer call-in remote-number [
callback ]
Configure the dialer number for
calling a remote end
calling a remote end
dialer number [ dial-number ]
Table 1134 Configuring ISDN leased line for Circular DCC
Operation
Command
Configure a B channel for ISDN
leased line connection
leased line connection
dialer isdn-leased channel-number
Delete the B channel for ISDN leased
line connection
line connection
undo dialer isdn-leased channel-number