3com 3031 Instruccion De Instalación
1054
C
HAPTER
76: DCC C
ONFIGURATION
Perform the following configuration in dial interface (physical or dialer interface)
view.
view.
By default, auto-dial is not configured. If auto-dial function is enabled, the interval
for auto-dial defaults to 300 seconds.
for auto-dial defaults to 300 seconds.
Configuring dialer number circular standby
This function can only be used with Circular DCC. When setting the same
destination addresses using Circular DCC, multiple
destination addresses using Circular DCC, multiple
dialer route
commands can
be configured, these commands corresponding to different dialer numbers. These
dialer route
commands form a kind of circular standby, i.e., which means that if
the calling dial number can not connect to peer end, then the number configured
in next
in next
dialer route
command will be selected automatically for re-calling.
Perform the following configuration in dial interface (physical or dialer interface)
view.
view.
Configuring Attributes
of DCC Dial Interface
Circular DCC and Resource-Shared DCC also have some optional parameters.
Flexibly configuring these parameters can improve DCC efficiency, and hence
satisfies various requirements.
Flexibly configuring these parameters can improve DCC efficiency, and hence
satisfies various requirements.
DCC dial interface attributes configuration overs the process to:
■
Configure the link idle time
■
Configure the link disconnection time before initiating the next call
■
Configure the link idle time when interface completion
■
Configure the timeout of call setting up
■
Configure the buffer queue length of the dial interface
Configuring the Link Idle Time
In the case that a dial interface originates a call, if the line is idle for an amount of
time, DCC will disconnect the line. The idle time means that in the duration of it
no packet in the ACL conforms the “permit” rule and needs to be transferred.
time, DCC will disconnect the line. The idle time means that in the duration of it
no packet in the ACL conforms the “permit” rule and needs to be transferred.
Table 1135 Configuring auto-dial
Operation
Command
Configure one (or more) remote
destination address(es) and dialer
number(s) that the router will
auto-dial
destination address(es) and dialer
number(s) that the router will
auto-dial
dialer route protocol next-hop-address
dialer-number autodial
Configure an auto-dial interval
dialer timer autodial seconds
Restore the default auto-dial interval
undo dialer timer autodial
Table 1136 Configuring dialer number circular standb
y
Operation
Command
Configure one remote destination
address(es) and dialer number(s)
address(es) and dialer number(s)
dialer route protocol next-hop-address
dialer-number autodial