3com 3031 Instruccion De Instalación
414
C
HAPTER
33: IP U
NICAST
P
OLICY
R
OUTING
C
ONFIGURATION
Typical Configuration
of IP Unicast Policy
Routing
of IP Unicast Policy
Routing
Configuring Policy
Routing Based on Source
Address
Configuration requirements
Enable a policy routing named aaa, which controls all TCP packets received from
Ethernet3/0/0 to be sent via the interface of serial1/0/0, whereas other packets to
be forwarded based on routing table.
Ethernet3/0/0 to be sent via the interface of serial1/0/0, whereas other packets to
be forwarded based on routing table.
Node 5 denotes that Ethernet packets matched with
acl 3101
will be sent to
serial1/0/0.
Node 10 denotes that any packets matched with
acl 3102
will not be processed
by policy routing.
The packets from Ethernet 3/0/0 will try to match the if-match clauses of nodes 5
and 10 in turn. If nodes in
and 10 in turn. If nodes in
permit
mode are matched, execute corresponding
apply clauses. If nodes in
deny
mode are matched, exit from policy routing.
Networking diagram
Figure 112 Networking diagram of configuring policy routing based on source address
Show the setting of the interface policy
routing
routing
display ip policy setup interface
interface-type interface-number
interface-type interface-number
Show the packet statistics of the local policy
routing
routing
display ip policy statistic local
Show the packet statistics of the interface
policy routing
policy routing
display ip policy statistic
interface interface-type
interface-number
interface interface-type
interface-number
enable the debugging of the policy routing
debugging ip policy
Table 469 Displaying and debugging IP unicast policy routing
LAN A 10.110.0.0
Serial2/0/0
Serial1/0/0
Ethernet3/0/0
Path1
Internet