3com 3031 Instruccion De Instalación

C

HAPTER

 35: IPX C

ONFIGURATION

a Activate IPX.

[3Com]ipx enable

b Activate IPX on the interface Ethernet2/0/0, with the network ID being 3.

[3Com]interface ethernet 2/0/0

[3Com-Ethernet2/0/0]ipx network 3

c Set packet encapsulation format on Ethernet interface to Ethernet_SNAP.

[3Com-Ethernet2/0/0]ipx encapsulation snap

[3Com-Ethernet2/0/0]quit

d Activate IPX on the interface Serial1/0/0, with the network ID being 1001.

[3Com]interface serial 1/0/0

[3Com-Serial1/0/0]ipx network 1001

[3Com-Serial1/0/0]quit

e Configure a static route to network ID 2

[3Com]ipx route-static 2 1000.00e0-fc01-0000 tick 7 hop 2

Configure a Server file service information item.

[3Com]ipx service 4 server 2.0000-0c91-f61f 451 hop 2

g Configure a Server directory service information item.

[3Com]ipx service 26B tree 2.0000-0c91-f61f 5 hop 2

[3Com]ipx service 278 tree 2.0000-0c91-f61f 4006 hop 2

Fault 1: IPX can not go UP on PPP link.

Confirm whether network IDs of both ends of the link are the same. Reconfigure 
them if they are different.

Confirm whether node IDs of both ends of the link are different. Reconfigure 
them if they are the same.

Fault 2: Fail in pinging destination address.

Confirm whether the Ping destination address is correct.

Use the 

 command to check the interface configuration 

on routers. The network ID and IPX frame encapsulation format of connected 
interfaces must be same.

Use the 

 command to display routing information. 

Check whether the destination network ID is reachable.

Enable IPX packet debugging switch using the 

 command. 

According to the detailed information displayed about IPX packets received, 
transmitted, forwarded and discarded, you can locate the error.