3com 3031 Instruccion De Instalación

Perform the following configuration in system view.

We can define several rules for a priority-list group and apply the rules to an 
interface. When a packet arriving the interface (Forwarding via this interface), the 
system will match this packet along the rule chain; if the packet matched with a 
certain rule, then it will enter the corresponding queue and the matching will be 
finished accordingly, otherwise, the packet will enter default queue. 

The default value for default queue is 

.

Configure the length of each queue (i.e. the capability of queue). 

Perform the following configuration in system view. 

The following table lists the default length of each queue.

Apply a group of Priority-list on the interface; to use this command repeatedly will 
set a new priority-list for the same interface. 

Perform the following configuration under interface view.

Not PQ but FIFO is employed on the interface by default.

Table 1011   Configuring default queue

Configure default queue

qos pql pql-index default-queue { top | 

Restore the default value of default 
queue

undo qos pql pql-index default-queue

Table 1012   Configuring length of the queue

Configure Length of the queue 

qos pql pql-index queue 

Recover the default length value of 
each queue

undo qos pql pql-index queue 

Table 1013   Default length of each queue

20

40

60

80

Table 1014   Applying priority-list group on the interface

Apply priority-list group on the interface

Cancel using PQ on the interface