Manualsbrain.com
  1. Manuales
  2. Marcas
  3. 3com
  4. 5012
  5. Manual De Usuario

3com 5012 Manual De Usuario

Descargar
Página de 162
3Com Router 5000/6000 Family
 
103
 
Command Reference
nat outbound static
Use the 
nat outbound static
 command to apply on the interface one-to-one address translation 
configured using the 
nat static 
command.
Interface view
nat overlapaddress
Use the 
nat overlapaddress
 command to map an overlapping address pool to a temporary address pool.
System view
nat server
Use the 
nat server
 command to define a mapping table for internal servers. Users can access the internal 
server with the address and port as host-addr and host-port respectively through the address port defined 
by global-addr and global-port.
Interface view
nat static
Use the 
nat static
 command to configure a one-to-one private-to-public address binding.
System view
nat static inside
Use the 
nat static inside 
command to create a static net-to-net NAT entry. When the router translates 
addresses based on this type of NAT entry, it translates the network address portion without touching the 
host address portion.
System view
nat traversal
Use the 
nat traversal
 command to configure the NAT traversal function of IKE/IPSec.
IKE-Peer view
national-bit
Use the 
national-bit
 command to configure national bit on the CE3 interface.
CE3 Interface view
naturemask-arp
Use the 
naturemask-arp enable
 command to support ARP within natural network segments rather than 
subnets.
System view
nbns-list
Use the 
nbns-list
 command to configure NetBIOS server addresses in a global DHCP address pool for 
the clients.
DHCP Address Pool view
nesting
Use the 
nesting
 command to configure a nesting rule.
ACL view
netbios-type
Use the 
netbios-type
 command to configure the NetBIOS node type of the clients of a global DHCP 
address pool.
DHCP Address Pool view
network
Use the 
network
 command to configure the network routes advertised by the local BGP system.
BGP view
network
Use the 
network
 command to configure an IP address range used for dynamic allocation.
DHCP Address Pool view
network
Use the 
network
 command to configure the network addresses to be sent by the local BGP.
IPv4 Multicast Subaddress Family view
network
Use the 
network
 command to configure the interface running OSPF.
OSPF Area view
network
Use the 
network
 command to enable Routing Information Protocol (RIP) on the interface.
RIP view