3com 5012 Manual De Usuario
120
3Com Router 5000/6000 Family
Command Reference
qos lr
Use the
qos lr
command to limit the transmitting rate of the interface.
Interface (including the MFR Interface) view
qos max-bandwidth
Use the
qos max-bandwidth
command to configure the maximum interface bandwidth used when CBQ
enqueues packets.
Interface view
qos policy
Use the
qos policy
command to define a policy and enter policy view.
System view
qos pq
Use the
qos pq
command to apply a group of priority list to an interface.
Interface view
qos pql default-queue
Use the
qos pql default-queue
command to designate the packets without corresponding rules to a
default queue.
System view
qos pql inbound-interface
Use the
qos pql inbound-interface
command to establish classification rules based on interfaces.
System view
qos pql protocol
Use the
qos pql inbound-interface
command to establish classification rules based on interfaces.
System view
qos pql queue
Use the
qos pql queue
command to specify the maximum number of packets that can wait in each of the
priority queues, or the length of a PQ.
System view
qos pql protocol mpls exp
Use the
qos pql protocol mpls exp
command to establish the classification rule based on MPLS protocol.
System view
qos reserved-bandwidth
Use the
qos reserved-bandwidth
command to set the maximum reserved bandwidth percentage.
Interface view
qos rtpq
Use the
qos rtpq
command to enable RTP queue feature on an interface so as to reserve a real-time
service for the RTP packets sent to some UDP destination port ranges.
Interface view
qos wfq
Use the
qos wfq
command to apply WFQ to and configure WFQ parameters on the interface or modify
WFQ parameters on the interface.
Interface view
qos wred
Use the
qos wred
command to apply WRED at an interface.
Interface view
qos wred dscp
Use the
qos wred dscp
command to set the lower limit, upper limit, and drop probability denominator of a
WRED DSCP.
Interface view
qos wred ip-precedence
Use the
qos wred ip-precedence
command to configure the minimum threshold, maximum threshold and
drop probability denominator for each precedence level in WRED.
Interface view
qos wred weighting-constant
Use the
qos wred weighting-constant
command to set exponential used to calculate the average length
of WRED queues.
Interface view
radius nas-ip
Use the
radius nas-ip
command to specify the source address of the RADIUS packet sent from NAS.
System view