3com 5012 Manual De Usuario
4
3Com Router 5000/6000 Family
Command Reference
address
Use the
address
command to configure a route to the peer voice gateway or assign an X.121 address for
a destination host.
Voice Entity view
address sip
Use the
address sip
command to set routing policy for reaching the remote voice gateway (VG) to SIP.
Voice Entity view
adsl standard
Use the
adsl standard
command to set the standard applied to the ADSL interface.
ATM (ADSL) Interface view
adsl tx_attenuation
Use the
adsl tx_attenuation
command to set attenuation value for ADSL transmit power.
ATM (ADSL) Interface view
adv-factor
Use the
adv-factor
command to configure the advantage factor which is used to count Mos and ICPIF
value in a jitter voice test.
HWPing Test Group view
aggregate
Use the
aggregate
command to establish an aggregated record in the BGP routing table.
BGP view
aggregate
Use the
aggregate
command to create a multicast aggregated record in the BGP routing table.
Use the
aggregate
command without parameters to create one local aggregated route and set atomic
aggregation attributes.
IPv4 Multicast Subaddress Family view
aging-time
Use the
aging-time
command to configure SYN status waiting timeout value and FIN status waiting timeout
value of TCP, session entry idle timeout value of TCP and UDP.
ASPF Policy view
ah authentication-algorithm
Use the
ah authentication-algorithm
command to set the authentication algorithm adopted by
Authentication Header protocol in IPSec proposal.
Use the
undo ah authentication-algorithm
command to restore the default setting.
IPSec Proposal view
ahdsl annex
Use the
shdsl annex
command to configure annex standard at an SHDSL interface. You cannot activate a
link with different standard types at its two ends.
ATM (G.SHDSL) Interface view
alarm (CT3 Interface)
Use the
alarm
command to enable the CT3 interface to detect/send alarm signals.
CT3 Interface view
alarm-threshold
Use the
alarm-threshold
command to configure the alarm thresholds on the CT1/PRI interface as needed.
CT1/PRI Interface view
algorithm-suite
Use the
algorithm-suite
command to specify the algorithm suite used when a client registers.
Dvpn-Class view
allow l2tp
Use the
allow l2tp
command to specify the name of the peer end of the tunnel on receiving call and the
Virtual-Template it uses.
L2TP Group view
annexg
Use the
annexg
command to enable T1.617 Annext G on the frame relay interface for data transmission.
DLCI view
ani
Use the
ani
command to enable or disable the terminating point to send the calling party information
(service category and calling number) to the originating point during call connecting process.
R2 CAS view