3com 5012 Manual De Usuario
6
3Com Router 5000/6000 Family
Command Reference
apply origin
Use the
apply origin
command to set the routing source of BGP routing information.
Routing Policy view
apply output-interface (for Multicast Policy Routing)
Use the
apply output-interface
command to configure an outgoing interface list in a route-node.
Route-Policy view
apply output-interface (for Unicast Policy Routing)
Use the
apply output-interface
command to set a packet forwarding interface.
Route-Policy view
apply policy outbound
Use the
apply policy outbound
command to set the frame relay virtual circuit queuing to CBQ
(Class-Based Queuing).
Frame Relay Class view
apply tag
Use the
apply tag
command to set the tag area of OSPF route information.
Routing Policy view
area
Use the
area
command to enter OSPF area view.
OSPF view
OSPF Area view
area
Use the
area
command to configure the type of busy tone detection for FXO voice subscriber-line.
Voice Subscriber-line view
area-authentication-mode
Use the
area-authentication-mode
command to configure IS-IS to authenticate the received Level-1
routing information packets (LSP, CSNP and PSNP), according to the pre-defined mode and password.
IS-IS view
area-id (Voice Entity view)
Use the
area-id
command to configure the area ID of voice GW.
Voice Entity view
area-id (Voice GK Client view)
Use the
area-id
command to configure the H.323 gateway area ID.
Voice GK Client view
arp check enable
Use the
arp check enable
command to enable ARP entry check to have the device not learn the ARP
entries with broadcast MAC addresses.
System view
arp-proxy enable
Use the
arp-proxy enable
command to enable proxy ARP on an interface.
Ethernet interface view
arp security
Use the
arp security
command to disable dynamic ARP learning on an Ethernet interface.
Ethernet Interface view
arp security time-out
Use the
arp security time-out
command to configure the aging time of the authorized ARP entries.
Ethernet Interface view
arp send-gratuitous-arp
Use the
arp send-gratuitous-arp
command to enable sending gratuitous ARP packet on this interface
periodically and set the sending period.
Bridge Template view
Ethernet Interface view
Ethernet Subinterface view
Gigabit Ethernet Interface view
Gigabit Ethernet Subinterface view
Virtual Ethernet interface view
VLAN Interface view
arp static
Use the
arp static
command to configure ARP mapping table.
System view