3com MSR 30-20 Instruccion De Instalación

Figure 22   Console cable

Follow these steps to connect the router to a console terminal:

Step 1: Select a console terminal.

It can be a standard ASCII terminal with an RS232 serial port, or more commonly, 
a PC.

Step 2: Connect the console cable.

Power down the router and the console terminal, connect the RS232 serial port on 
the console terminal to the console port on the router through the console cable.

Verify the connection and power up the devices. The console terminal shows the 
startup information of the router if the connection is correct.

H3C MSR 30 Series provide fixed Ethernet interfaces, the MSR 30-11 and MSR 
30-16 provide two fixed FE interfaces, the MSR 30-20 provides two fixed GE 
interfaces and the MSR 30-40/30-60 provides two fixed Combo interface. In 
addition, H3C MSR 30 Series Routers provide SIC and DSIC slots except that MSR 
30-11 does not provide any DSIC slot). The MSR 30-11/30--16/30-20 provides 
MIM slots and the MSR 30-40/30-60 provides MIM slots and DMIM slots. The MSR 
30-11 provides one XMIM slot. These SIC and MIM slots can expand Ethernet 
interface card and interface module. For the expansion rules, refer to H3C MSR 
20/30/50 Series Routers Interface Card and Interface Module Manual. The 
following table describes Ethernet interface attributes.

A

A

Table 23   Attributes of the Ethernet interface

Connector RJ-45 

Interface MDI/MDIX auto-sensing 

Frame format 

Ethernet_II

Ethernet_SNAP 

Operating mode 

10/100/1000 Mbps auto-sensing (10/100 Mbps 
auto-sensing for FEs)

Full duplex/half duplex