Gestetner 1045 Guía Del Usuario
Windows 95/98/Me Configuration
2
1
Configuring Protocols
Configuring TCP/IP and IPP for Printing
These instructions are for configuring the Network Interface Board and Win-
dows 95/98/Me to use the TCP/IP protocol and IPP.
dows 95/98/Me to use the TCP/IP protocol and IPP.
Configuring the machine
Configure the machine to use the TCP/IP protocol.
• Make sure that the TCP/IP protocol is set to active. (The default is active.)
• Assign an IP address and make other settings required for using the TCP/IP
• Make sure that the TCP/IP protocol is set to active. (The default is active.)
• Assign an IP address and make other settings required for using the TCP/IP
protocol.
Reference
For more information about how to make the above settings, see the System
Settings.
If DHCP is used to assign IP addresses, see P.90 “When Using DHCP”.
For more information about how to make the above settings, see the System
Settings.
If DHCP is used to assign IP addresses, see P.90 “When Using DHCP”.
Note
❒ After setting the IP address, use the ping command to make sure that it has
been set correctly.
A
Click [Start], point to [Programs], and then click [MS-DOS Prompt].
B
Type the following: (Example IP address is 192.168.15.16)
C:\> ping 192.168.15.16
If the address has been configured correctly, the following message ap-
pears.
Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32
If the address has been configured incorrectly, the following message ap-
pears.
Request timed out.
C:\> ping 192.168.15.16
If the address has been configured correctly, the following message ap-
pears.
Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32
If the address has been configured incorrectly, the following message ap-
pears.
Request timed out.
Configuring a Windows 95/98/Me computer
These steps are for configuring a Windows 95/98/Me computer to use the TCP/
IP protocol.
IP protocol.
A
Open [Control Panel] and double-click the [Network] icon. Make sure that
“TCP/IP” is listed in the [The following network components are installed:] box on
the [Configuration] tab.
“TCP/IP” is listed in the [The following network components are installed:] box on
the [Configuration] tab.
Note
❒ If the TCP/IP protocol is not installed, click [Add] on the [Configuration] tab
to install it. For more information about installing the TCP/IP protocol, see
Windows 95/98/Me Help.
Windows 95/98/Me Help.