Gestetner dsm725e Guía De La Red
Remote Maintenance by telnet
71
2
❖ IP TTL setting
msh> rendezvous ip ttl {1-255}
You can specify the IP TTL (the number of routers a packet can pass through).
You can specify the IP TTL (the number of routers a packet can pass through).
Note
❒ The default is 255.
❖ Resetting the computer name and location information
You can reset the computer name and location information.
msh> rendezvous clear {cname | location}
• cname
Reset the computer name. The default computer name will be displayed
when the computer is restarted.
when the computer is restarted.
• location
Reset the location information. The previous location information will be
deleted.
deleted.
❖ Interface configuration
msh> rendezvous linklocal “interface_name”
• If many types of interface are installed, configure the interface that com-
municates with linklocal address.
• If you do not specify an interface, the Ethernet interface is automatically se-
lected.
• wlan can be specified only when the IEEE 802.11b interface is installed.
route
Use the “route” command to view and control the routing table.
❖ Specified route information display
msh> route get “destination”
• Specify the IP address to destination.
“0.0.0.0” cannot be specified as destination address.
❖ Enabling/disabling specified IP destination
msh> route active {host|net} “destination” {on | off}
• You can turn the specified destination on or off. Host becomes the default
setting.
Interface
Interface configured
ether
Ethernet interface
wlan
IEEE 802.11b interface