Gestetner f104 Guía De Operación
More Transmission Functions
65
3
Note
❒ You can display the communica-
tion result on the display. See p.35
“Checking the Transmission Re-
sult (TX Status)” and p.36 “Check-
ing the Reception Result (RX
Status)”.
“Checking the Transmission Re-
sult (TX Status)” and p.36 “Check-
ing the Reception Result (RX
Status)”.
❒ The communication result of
Memory Transmission or Immedi-
ate Transmission can be printed in
the Journal. See p.40 “Printing the
Journal”.
ate Transmission can be printed in
the Journal. See p.40 “Printing the
Journal”.
Broadcasting Sequence
If you specify several destinations for
the same message (Broadcasting), the
messages are sent in the order in
which they were specified. If the doc-
ument could not be transmitted, the
machine redials that destination after
the last destination specified for
Broadcasting. For example, if you
specify four destinations, A through
D for Broadcasting, and if the lines to
destinations A and C are busy, the
machine dials the destinations in the
following order: A, B, C, D, A, and C.
the same message (Broadcasting), the
messages are sent in the order in
which they were specified. If the doc-
ument could not be transmitted, the
machine redials that destination after
the last destination specified for
Broadcasting. For example, if you
specify four destinations, A through
D for Broadcasting, and if the lines to
destinations A and C are busy, the
machine dials the destinations in the
following order: A, B, C, D, A, and C.
Note
❒ The dialing order mentioned
above does not apply in the Batch
Transmission mode.
Transmission mode.
❒ For details about Broadcasting, see
p.29 “Transmission Modes”, Basic
Features.
Features.
Simultaneous Broadcast
Normally, if you specify several des-
tinations, the messages are sent in the
order in which they were specified.
However, with this feature, you can
send messages to more than one des-
tination simultaneously, using sepa-
rate communication lines.
You can complete the entire transmis-
sion in a shorter time with this feature
than with Broadcasting.
tinations, the messages are sent in the
order in which they were specified.
However, with this feature, you can
send messages to more than one des-
tination simultaneously, using sepa-
rate communication lines.
You can complete the entire transmis-
sion in a shorter time with this feature
than with Broadcasting.
Note
❒ This feature requires the optional
extra G3 interface unit.
❒ Up to two lines can be used simul-
taneously. When the optional extra
G3 interface unit is installed, it is
more efficient to set the line type of
the destination to "Auto" so that
the transmission is made with the
available G3 line.
G3 interface unit is installed, it is
more efficient to set the line type of
the destination to "Auto" so that
the transmission is made with the
available G3 line.
StellaF2_EN_Combine_F_FM.book Page 65 Friday, February 14, 2003 5:16 PM