Gestetner f104 Manual Suplementario
Transmitting IP-Fax
101
5
EEEE
Press the
{{{{OK}}}} key.
FFFF
Press the
0
0
0
0 or 1
1
1
1 key to select
"Yes".
GGGG
Press the
{{{{OK}}}} key.
The display for entering the VoIP
gateway address appears.
gateway address appears.
HHHH
Enter the IP address or host name
of the VoIP gateway.
of the VoIP gateway.
IIII
Press the
{{{{OK}}}} key.
JJJJ
If you want to specify another
destination, press the
destination, press the
{{{{OK}}}} key,
and then repeat steps
.
Note
❒ If you do not want to specify
other destination, proceed to
step
step
.
KKKK
Press the
{{{{Start}}}} key.
The IP-Fax transmission begins.
Transmitting by Specifying an
Alias Fax Number
Alias Fax Number
This section describes how to send fax
messages by specifying an alias fax
number of a destination stored in the
gatekeeper.
messages by specifying an alias fax
number of a destination stored in the
gatekeeper.
Preparation
You need to set the gatekeeper ad-
dress as well as alias fax number
beforehand with IP-Fax Parameter
settings. See p.43 “IP-Fax Parame-
ter Settings”.
Also, you need to make settings for
using the gatekeeper for IP-Fax
transmission with user parame-
ters. For information about making
these settings, see p.166 “User Pa-
rameters” (switch 32, bit 0).
You need to set the gatekeeper ad-
dress as well as alias fax number
beforehand with IP-Fax Parameter
settings. See p.43 “IP-Fax Parame-
ter Settings”.
Also, you need to make settings for
using the gatekeeper for IP-Fax
transmission with user parame-
ters. For information about making
these settings, see p.166 “User Pa-
rameters” (switch 32, bit 0).
Note
❒ Alias fax numbers are fax numbers
stored in the gatekeeper and valid
only within the network.
only within the network.
❒ If you change the settings for using
or not using the gatekeeper, you
need to program the destinations
for the Quick Dial or Speed Dial
again. Normal IP-Fax transmission
is not possible without performing
this procedure.
need to program the destinations
for the Quick Dial or Speed Dial
again. Normal IP-Fax transmission
is not possible without performing
this procedure.
AAAA
Set the original, and then select
the scan settings as necessary.
the scan settings as necessary.