Gestetner f540 Guía De Operación

Reception Features

HHHH

Specify the end receiver, and then
press the

{{{{q

q}}}} key.

If the End Receiver is correct, you
will hear a "peeee" tone.

Specifying the end receiver with a
Quick Dial key

A Enter the number (01-90) of the

Quick Dial key.

Specifying the end receiver with a
Speed Dial

A Press the {{{{p

p}}}} key, and then

enter the Speed Dial code (000-
199).

Note

❒ If the End Receivers only

support 2 digits for the Speed
Dials, enter the number with
2 digits.

Specifying the end receiver with a
Group Dial

A Press the {{{{p

p}}}} key twice, and

then enter the group number
(1-9).

Note

❒ Specify an end receiver that

has been stored in a Quick
Dial key , Speed D ial, o r
Group Dial.

❒ If you hear a "pee pee pee

pee" tone, specify the end re-
ceiver again.

❒ If you keep on getting the er-

ror tone, the End Receiver
may not be registered in the
destination you are specify-
ing.

IIII

Repeat step

HHHH for all End Receiv-

ers.

Note

❒ If you specify 30 End Receivers,

the Transfer Request is accepted
and you will hear a "pee pee pee
pee" tone. In this case, proceed
to step

JJJJ

Press the

{{{{q

q}}}} key twice.

The Transfer Request is accepted
and you will hear a "pee pee pee
pee" tone.

KKKK

When you hear the reception tone
again, press the

{{{{Start}}}} key.

Your document will be sent.

ID Reception

If you want to limit reception of mes-
sages to those from machines of the
same make and with the same Polling
ID, contact your service representa-
tive to enable this feature.

Reference

p.148 “ID Codes”
p.52 “ID Transmission”

JBIG Reception

Use this feature to receive messages
sent to you using the high compres-
sion protocol known as JBIG (Joint Bi-
level Image Experts Group).

Reference

p.59 “JBIG Transmission”

StellaF25_EN_Combine_F_pre_FM.book Page 74 Thursday, August 26, 2004 8:45 PM