Gestetner f540 Manual Suplementario

Troubleshooting

164

If one of the messages listed below appears on the Windows display, follow the
instructions given here.

Toner Almost Empty

The toner level is low. Replace the toner cartridge 
before the toner runs out.

See Chapter 4 "Replacing the Toner Cartridge", Ba-
sic Features.

Call Service Center

Contact your service representative.

Cannot connect to the 
printer. If you select [Re-
try]

, the data will be sent to 

the printer again.

• No destination is programmed under the specified Quick Dial, 

Speed Dial, or Group Dial code when using LAN-Fax trans-
mission. Click [Cancel].
Specify a Quick Dial, Speed Dial, or Group Dial code which the 
destination is already programmed under and send the docu-
ment again, or program the destination under the Quick Dial, 
Speed Dial, or Group Dial code.

• The memory limit was reached during a LAN-Fax transmis-

sion.
Click [Cancel] to cancel the transmission, and then divide the 
document you want to send into parts for multiple transmis-
sions. If there are any documents in memory waiting to be sent 
or printed with Substitute Reception, try to send the document 
again after transmission or printing of these is complete.

• Check the network connection.

• Check the power of NIC FAX is turned on.

The number of entries in 
Destinations exceed the 
limits.

Up to 100 entries can be 
entered.

The number of destinations specified exceeds the limit. The maxi-
mum number of destinations that can be specified at one time is 
100.

Up to 1500 characters can 
be entered.
Please check.

The total number of characters used for the specified destinations 
exceeds the limit. The maximum number of characters that can be 
entered is 1500.

"LAN-Fax" has already 
been launched. Cannot 
launch it again.

The LAN-Fax dialog box is already open. Exit LAN-Fax once, and 
then start it up again.

Failed to allocate memory. Available memory is insufficient.