Preh mc12t4 Guía Del Usuario
13
subject to change without prior notice
05.2004
Preh KeyTec GmbH, www.preh-keytec.com
OSD H. POSITION
With this menu point the horizontal position of the OSD menu (left/right) can be
adjusted on the display.
OSD V. POSITION
adjusted on the display.
OSD V. POSITION
With this menu point the vertical position of the OSD menu (up/down) can be
adjusted on the display.
OSD TIMER
adjusted on the display.
OSD TIMER
With this menu it can be adjusted for how long the menu is to be shown on the
screen after pressing a OSD button.
POWER SAVE
screen after pressing a OSD button.
POWER SAVE
The monitor could status in low power mode, if POWER SAVE is ON
DITHERING
DITHERING
Should be set to ON. Special Applications could claim the setting OFF.
3.4
Mechanical Adjustment of the LCD Position
The LCD position on a VESA Mount Preh Touch / Screen Commander cannot be
changed directly at the Product. The adjustment (tilting or swinging) of the Touch
Screen Commander depends on the pole or wall mount hardware used.
The LCD of the Preh Touch / Screen Commander is swingable and tillable. According
to the usage the LCD position can be changed.
The right picture shows the model with the modular base.
Pict. 17: adjusting screws on rear side
The infinitely variable adjustment of the tilting force can be made with two adjusting
screws located on the rear of the monitor. The adjustment torque (1 - 8 Nm) should
be about the same on both screws.