Preh mc12t4 Guía Del Usuario
14
subject to change without prior notice
05.2004
Preh KeyTec GmbH, www.preh-keytec.com
Pict. 18: adjusting screws below
The infinitely variable adjustment of the swinging force can be made with two
adjusting screws in the base of the monitor. The adjustment torque (1 - 8 Nm) should
be about the same on both screws.
Note: On changing the housing position you should be careful to not get your fingers
too near to the opening on the rear side of the housing as they might get pinched
there.
adjusting screws in the base of the monitor. The adjustment torque (1 - 8 Nm) should
be about the same on both screws.
Note: On changing the housing position you should be careful to not get your fingers
too near to the opening on the rear side of the housing as they might get pinched
there.
4 Driver
Installation
Important Note:
A new calibration is always necessary if another touchscreen was connected to the
computer or if the screen resolution was changed. This means that the calibration
between touchscreen and computer is adjusted to the mechanical features of the
particular touchscreen which was connected to the computer at that time.
A serial Accu Touch Controller E271-2210 (Controller model Smart Set 2xx0) is
integrated into the Preh Touch Commander. The default setting is 9600 Bps.
Normally this is clearly recognized by the setup programs. If, however, it is not clearly
recognized, the adjustment can be done manually or by restarting the corresponding
setup program.
Information for the driver installation is in the file:
D:\TOUCH\ELO\README.TXT
You can find detailed information in the path, named with your operating system.
(The CD-ROM drive of your Preh-CD is here defined with the letter „D“).
computer or if the screen resolution was changed. This means that the calibration
between touchscreen and computer is adjusted to the mechanical features of the
particular touchscreen which was connected to the computer at that time.
A serial Accu Touch Controller E271-2210 (Controller model Smart Set 2xx0) is
integrated into the Preh Touch Commander. The default setting is 9600 Bps.
Normally this is clearly recognized by the setup programs. If, however, it is not clearly
recognized, the adjustment can be done manually or by restarting the corresponding
setup program.
Information for the driver installation is in the file:
D:\TOUCH\ELO\README.TXT
You can find detailed information in the path, named with your operating system.
(The CD-ROM drive of your Preh-CD is here defined with the letter „D“).